Connecting The Lines; Preparing The Filter System; Operation; Pump Operation - Steinbach Active Balls 50 Manual Del Usuario

Connecting the lines

Prepare the following components:
- Pressure line
14
- Return line and suction line (not included in the package contents)
- Assembly materials for the lines
To connect the lines to the pump and filter vessel (see Figure A), proceed as follows:
1. Route the return line and suction line from the pool to the filter system.
Observe the markings on the connections and on the filter cover .
The lines are connected.

Preparing the filter system

1. Remove the stopper on the suction line if applicable.
2. Check that the suction line is free and then open the shut-off valve on the suction line.
The filter system fills automatically with water because it is below the water level.
3. Let the filter vessel fill completely with water.
4. Bleed the filter system. Open the prefilter cover
ring until water flows from the prefilter cover.
13
5. Let the prefilter cover fill completely with water.
6. Check the filter system and the connections for leaks.
In the case of leaks, wrap extra Teflon tape around the affected connections.

Operation

Risk of death when operating the water treatment system during bathing.
Hair or clothing might get sucked into the suction openings of the pool and in extreme cases
trap persons under water and prevent them from surfacing again.
- Never operate water treatment system devices while persons are in the pool.
- Prevent any access to the pool for as long as water treatment system devices are in use.
A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see section "Testing").
Clarifying agents in the pool water can lead to clumping of the Active Balls and severely
impair their cleaning effect.
- Do not use any clarifying agents for water treatment when using Active Balls as filter
medium.

Pump operation

1. Make sure that all hoses and pipes are correctly connected and that the water level in the pool is at
least 1 to 2" (2.5 to 5 cm) above the opening of the suction line.
2. Connect the pump's power plug to the power supply.
The running time display blinks (if a battery is inserted, the last selected running time is displayed).
3. Press the timer button
34
11
WARNING!
CAUTION!
Risk of injury!
NOTICE!
several times until the LED of the desired running time is lit.
29
on the pump slightly by loosening the threaded