Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
P R E - I N S TA L L AT I O N
Find a suitable mounting location:
•
Mount within wiring range of the LS0 luminaire. A total of 50 ft (15 m) of cable can be used,
from the X96 Ketra controller to the last LS0 luminaire, including cabling in between luminaire
segments.
•
The X96 Ketra controller, a Clear Connect Type X device, must be mounted within 71 ft (21.5 m) of its
assigned gateway. The X96 must have at least two Type X devices with 25 ft (7.5 m). Within a subnet,
groups or clusters of Type X devices must not be separated by greater than 25 ft (7.5 m). The gateway
and the Type X devices assigned to it must be on the same floor.
•
Mount a minimum of 3 ft (1.0 m) away from interference sources in the 2.4 GHz band, including
but not limited to microwaves, wireless access points, hotspots, baby monitors, thermostats,
and voice recognizing control devices.
•
Do not install the controller inside a third-party enclosure. Performance of Type X devices can
severely degrade if installed inside metal enclosures.
•
For additional guidelines regarding Type X devices, refer to Lutron Application Note #745
(P/N 048745) at www.lutron.com
•
A minimum of 2 in (51 mm) of free space is required all around
the controller. See Figure 1.
•
Mount the controller in a position where it can be easily
located and accessed if service or troubleshooting is
necessary.
•
Ensure that the reset button and output connector can be
accessed. See Figure 2.
•
Ensure there is sufficient space above the junction box to
drive the mounting screws and attach the top cover.
•
Ensure that the junction box is rotated to allow the output
wiring on the controller to route towards the first LS0
luminaire.
P/N 3662641 Rev A
© 2021 Lutron Electronics Co., Inc.
Figure 1
2 in
(51 mm)
7 in
2 in
(178 mm)
(51 mm)
X96 INSTALLATION GUIDE | 5
4.5 in
(89 mm)
2 in
(51 mm)
Publicidad
Tabla de contenido
