Main Components - Probuilder 69360 Manual De Instrucciones

Connection
a. Compressed air tool
b. Connector
c. Snap coupling
d. Compressed air hose
e. Connector
f. Snap coupling
g. Lubrication unit
h. Regulator
i. Filter
j. Non-return valve
k. Compressor

Main components

6 6
1. Handle
2. Compressed air nozzle
3. Trigger
4. Magazine release
5. Magazine
6. Safety release
28
1 1
2 2
3 3
4 4
5 5
Use
Loading staples
Check that the staple gun is not connected
to the compressed air supply.
Press the magazine release (4) and open the
magazine (5).
Load the required staples into the magazine.
The points must point downwards and the
staples should be pushed forward by the
feeder.
Close the magazine. Check that it clicks into
place and cannot be pushed to one side
without pressing the release.
Adjusting the discharge depth
Connect the staple gun to the air supply, and
check that the supply air pressure is correct.
Use the regulator on the air supply (h) to
adjust the distance the nails are to be driven
into the item.
Check the discharge depth is correct on a
piece of scrap wood before using the staple
gun on the item.
Discharging staples
Load the staples required and adjust the
discharge depth as described above.
Grip the handle (1), place the staple gun
against the item so that the safety release (6)
is depressed and press the trigger (3) to � re a
staple. Release the trigger.
Do not put too much pressure on the staple
gun.
Disconnect the staple gun from the air hose
after use.