Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1. When unpacking, check to make sure that the item is intact and undamaged.
2. This air tool may be shipped with a protective plug covering to the air inlet.
Remove this plug before set up.
3. Screw the quick coupler into the air inlet thread.
4. Install of accessory:
1 Pins
2 Angled Cutting Blade
3 Output Shaft
a. While the air hose is disconnected from the tool, hold the Output Shaft with a 13mm wrench, and
unthread the Cap Screw using the Hex Wrench.
b. Remove the Cap Screw and Retainer.
c. Install the desired accessory in any one of seven orientations by aligning four of the holes in the
accessory over the four pins on the Output Shaft.
d. Note: When attaching the Angled Cutting Blade Accessory, orient the accessory as shown at left
so the Cap Screw will be out of the way when working.
e. Replace the Retainer and Cap Screw while holding the blade.
f.
Hold the Output Shaft with the wrench, than tighten securely using the Hex Wrench.
g. Note: For sanding, first attach the Sanding Pad to the tool, then align a sheet of sand paper over
the pad and press into place.
5. Make sure that all screws of the tool are tightened.
6. Check the trigger whether it is easy to move and in OFF position.
7. Add a few drops of pneumatic tool oil into the air connection.
8. Connect the tool to compressed air.
9. To begin use, push the Safety Catch forward while squeezing the Trigger Lever.
A stable two-handed grip on this tool is best.
10. Adjust pressure on the Trigger Lever to change the speed of the tool.
11. Note: Do not force the tool. Let the tool do the work.
12. If the tool requires more force to accomplish the task, verify that the tool receives sufficient,
unobstructed airflow (CFM) and increase the pressure (PSI) output of the regulator up to the maximum
air pressure for this tool.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Publicidad
Tabla de contenido
