Using the clock, timer and control lockout.
Make sure the clock is set
to the correct time of day.
The timer is a minute timer only.
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 59
minutes.
All manuals and user guides at all-guides.com
To Set the Clock
The clock must be set to the correct time of day
for the automatic oven timing functions to work
properly. The time of day cannot be changed
during a timed baking or self-cleaning cycle.
To Set the Timer
Press the Kitchen Timer On/Off pad.
Press the number pads until the amount
of time you want shows in the display. For
example, to set 2 hours and 45 minutes,
press 2, 4 and 5 in that order. If you make
a mistake, press the Kitchen Timer On/Off
pad and begin again.
Press the Start pad.
After pressing the Start pad, SET disappears;
this tells you the time is counting down,
although the display does not change until one
minute has passed. Seconds will not be shown
in the display until the last minute is counting
down.
To Reset the Timer
If the display is still showing the time remaining,
you may change it by pressing the Kitchen
Timer On/Off pad, then press the number pads
until the time you
want appears in the display.
To Cancel the Timer
Press Kitchen Timer On/Off pad twice.
Control Lockout
Your control will allow you to lock out the touch
pads so they cannot be activated when pressed.
NOTE: On double oven models, this activates
this feature for both ovens.
To lock/unlock the controls:
Press the 9 and 0 pads at the same time
for 3 seconds, until the display shows LOC
ON.
To unlock the control, press the 9 and 0
pads at the same time for 3 seconds, until
the display shows LOC OFF.
Press the Clock pad.
Press the number pads.
Press the Start pad.
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the Kitchen Timer
On/Off pad is pressed.
The 6-second tone can be canceled by
following the steps in the Special features of
your oven control section under Tones at the
End of a Timed Cycle.
If the remaining time is not in the display (clock,
delay start or cooking time are in the display),
recall the remaining time by pressing the
Kitchen Timer On/Off pad and then pressing
the number pads to enter the new time you
want.
When this feature is on and the touch pads are
pressed, the control will beep and the display
will show LOC ON.
NOTES:
■
The control lockout mode affects all touch
pads. No touch pads will work when this
feature is activated.
■
The adjustment will be retained in memory
after a power failure.
9