Deleting Whole Key Codes Of A Device - Teac RC-L800 Manual Del Usuario

Deleting Whole Key Codes of a
Device
1. Enter the setup mode.
2. Press 5 or b to select CODE and press
ENTER.
3. Press 5 or b to select DEL KEY and press
ENTER.
4. Press 5 or b to select DEL BANK and press
ENTER.
14
Deleting Key Code 2
5. By pressing the device and page buttons,
6. Press the
7. Press ENTER to delete.
< Press MENU to escape from deleting.
< When deleted,
8. Press the
Note:
< If at any point during setup you wish to exit from
< If you delete a device by mistake you can re-
select the screen page from which you wish
to delete all key codes.
If a page is selected, all key codes are deleted
from the device.
button. A confirmation
message appears.
button repeatedly to exit and
return to the previously displayed screen
layout.
the setup screens, press the
back through the displayed screens one by one.
program the RC-L800/RC-L2 by following the
steps on page 8, Pre-programmed Code Setting,
or page 11, Learning a Device.
flashes briefly.
button to go