Teac RC-L800 Manual Del Usuario página 9

Setting Key Codes 2
6. Once the target component is on, point the
remote control towards the target
component and press the POWER button. If
the target component responds to the
POWER button, the device 4-digit code has
been entered successfully.
Note:
If the target component does not respond to the
POWER button the 4-digit code may be incorrect.
Confirm the 4-digit code for the target component
on the attached sheet and enter it again.
7. Press the button to complete the setup
for the target component.
< If setup was successful,
on the screen when you press the
and the display returns to the previous screen.
< If setup was not successful,
flashes on the screen when you press the
button. Confirm the 4-digit code for the target
component on the attached sheet and enter it
again.
8. Press the button repeatedly to exit from
Manual setup and return to the previously
displayed screen layout.
Note:
If at any point during setup you wish to exit from
the setup screens, press the
through the displayed screens one by one.
briefly flashes
button
briefly
button to go back
9