OPERATION
STARTING OPERATION
● Observe correct mains voltage! The voltage of the
power source must agree with the voltage specifi ed
on the nameplate of the machine. Power tools mar-
ked with 230 V can also be operated with 220 V.
Switching On and Off
To start the machine, push the On/Off switch 4 to the
right.
To switch off the machine, push the On/Off switch 4
to the left.
For low temperatures, the machine reaches the full im-
pact rate only after a certain time.
This start-up time can be shortened by striking the chi-
sel in the machine against the fl oor one time.
WORKING ADVICE
● Before any work on the machine itself, pull the mains
plug.
Sharpening Chisels (see fi gure C)
Good results are only achieved with sharp chisels; the-
refore, sharpen the chiselling tools in good time. This
ensures a long service life of the tools and good wor-
king performance.
Re-sharpening
Sharpen chiselling tools using grinding wheels (e. g.
ceramic bonded corundum wheel) with a steady supp-
ly of water. Reference values are shown in the fi gure.
Take care that no annealing coloration appears on the
cutting edges; this impairs the hardness of the chi-
selling tools.
For forging, heat the chisel to between 850 and 1050
°C (bright red to yellow).
For hardening, heat the chisel to approx. 900 °C and
quench in oil. Then anneal in an oven for approx. one
hour at 320 °C
(annealing colour = light blue).
MAINTENANCE AND SERVICE
MAINTENANCE AND CLEANING
● Before any work on the machine itself, pull the mains
plug.
● For safe and proper working, always keep the ma-
chine and ventilation slots clean.
● A damaged dust protection cap should be changed
immediately.
Your machine is double insulated in accor-
dance with EN60745 ; therefore no earthwire
is required.
MAINTENANCE
Make sure that the machine is not live when
carrying out maintenance work on the motor.
Regularly clean the machine housing with a soft cloth,
preferably after each use. Keep the ventilation slots
free from dust and dirt.If the dirt does not come off use
a soft cloth moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water, etc.
These solvents may damage the plastic parts.
The machine requires no additional lubrication.
Should a fault occur, e.g. after wear of a part, please
contact your local SBM Group dealer.
ENVIRONMENT
In order to prevent the machine from damage during
transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these
materials to the appropriate recycling locations. Take
your unwanted machines to your local SBM Group
dealer. Here they will be disposed of in an environmen-
tally safe way.
GB
9