General Maintenance - Ego Power+ LB7650E Manual Del Usuario

EN
◾
To Remove (Fig. C3)
Press and hold the nozzle-release button to disengage
the latch, then pull the nozzle straight from the blower
tube.
Follow the same sequence to assemble or remove the
spread nozzle.
OPERATION
WARNING:
Before each use, inspect the entire
product for damaged, missing, or loose parts, such
as screws, nuts, bolts, caps, etc. Tighten securely all
fasteners and caps and do not operate this product until
all missing or damaged parts are replaced.
ATTACHING/DETACHING THE BATTERY PACK
Use only with EGO's battery packs and chargers listed in
Fig. A2.
FULLY CHARGE BEFORE FIRST USE
To attach
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click" (Fig. D1).
D1-1 Battery Rib
D1-3 Battery-release button
To detach
Depress the battery-release button and pull the battery
pack out (Fig. D2).
STARTING/STOPPING THE BLOWER (Fig. E)
Air-speed trigger only
1. Depress the air-speed trigger to turn on the blower.
2. The air speed of the blower is controlled with the
variable speed trigger. More pressure on the trigger
results in higher blowing speeds; less pressure on
the trigger results in lower blowing speeds. Adjust
the speed to suit the task at hand.
3. Release the air-speed trigger to turn off the blower.
Speed/Lock-on dial only
The blower can be locked at any speed with the speed
lock-on dial.
1. Turn the speed/lock-on dial clockwise to start the
blower. The air speed will increase as the dial is
rotated clockwise.
2. To decrease the air speed, turn the speed/lock-on
dial counterclockwise.
6
56 VOLT LITHIUM-ION CORDLESS BLOWER – LB7650E
D1-2 Mounting Slot
3. Keep turning the speed/lock-on dial counterclockwise
to the off position to stop the blower.
NOTICE:
If the speed/lock-on dial is not turned back to
the off position before the battery is removed, the blower
will not start when a fully charged battery is installed. This
is a protection feature to help prevent accidental startup.
Depress the air-speed trigger to deactivate the protection
and start the blower.
Boost mode
Press the boost button while working to temporarily
increase the air speed to the maximum level. The blower
will resume the previous speed when the boost button is
released.
E-1 Air-speed Trigger
E-3 Boost Button
TIPS FOR USING THE BLOWER
◾
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
◾
To reduce sound levels, limit the number of pieces of
power equipment used at any one time.
◾
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces if water
is available.
◾
Conserve water by using power blowers instead
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
◾
The edge of the tapered nozzle helps with removing
wet leaves and clean out gaps in the sidewalk.
◾
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
◾
After using blowers or other equipment, clean up!
Dispose of debris properly.
MAINTENANCE

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types
of commercial solvents and may be damaged by their
use. Use of a piece of clean cloth to remove dirt, dust, oil,
grease, etc.
E-2 Speed/Lock-on Dial