Using The Laser - Wacker Neuson PAL 450 Manual De Operación

All manuals and user guides at all-guides.com
PAL 450
2.4

Using the Laser

See Graphic: wc_gr004579
Setup:
The laser mounts to any 5/8" x 11 tripod (flathead or domed) or can
rest on any stable flat surface (floor, bricks, etc.). Position the tripod,
attach the laser, then adjust the tripod until it is rough leveled (within ±
4° self-leveling range).
Turning on the Laser:
Press the ON / OFF key (4) to power up the laser. The unit's self-
checking system will start automatically. Both LEDs (5 and 6) will flash
if anything goes wrong during the self-check procedure. The battery
LED should be green. If batteries are low, the battery LED will be red
or both LEDs will flash.
Leveling:
When the laser is turned on, the level indicator LED (5) will flash red
until the unit is level. If the laser fails to self-level within 90 seconds, the
LED will light and remain lit. Re-adjust the tripod to bring the laser into
self-leveling range. When the unit is level, the rotor head will begin
spinning at 600 rpm.
Level Alert:
If laser is disturbed, the level alert system will stop head rotation. The
laser will self-level and return to operation automatically unless it is
disturbed again while in the self-leveling range (± 4°). Always recheck
the beam height against a benchmark when releveling is required.
Power Sources:
The laser can be operated with the alkaline battery pack (4 D-size
batteries) or the optional NiCd rechargeable battery pack. If using a
NiCd battery pack, charge it completely before flrst use. The NiCd
battery pack can also be charged while working. If electricity is
available on the job site, simply plug in the charger and keep working.
wc_tx000804gb.fm
EN-11
Operation