Uline H-7008 Guia De Inicio Rapido página 2

NOTE: Two person assembly required.
NOTE: Do not tighten bolts until instructed.
NOTE: Bolt heads should face towards the
outside of the cabinet for added security.
1. Place one side panel on the ground with the flat
side down.
2. Attach back panel to side panel using three
bolts and nuts. (See Figure 1)
NOTE: Back panel should be positioned behind
side panel.
Figure 1
3. Stand upright and attach other side panel to back
using three bolts and nuts. (See Figure 2)
Figure 2
4. Lay cabinet down on back panel.
PAGE 2 OF 9
ASSEMBLY
5. Attach top panel to side and back panels using six
bolts and nuts. (See Figure 3) Tighten bolts along the
back panel only. Leave the bolts towards the front of
the cabinet loose.
6. Attach the bottom panel to the back and side
panels using six bolts and nuts. (See Figure 3)
Tighten all bolts used to connect the bottom panel.
NOTE: Bottom panel for H-7008 has two
horizontal supports affixed. Bottom panel for
H-7617 has one.
Figure 3
7. Stand cabinet upright.
8. Tighten all remaining bolts.
9. While facing the front of the cabinet, add hinges to the
top two and bottom two holes on the front right leg of
the cabinet using four bolts and nuts.
a. Ensure proper hinge configuration. (See Figure 4)
b. Slotted holes should connect to the frame of the
cabinet. (See Figure 4)
c. Round holes should connect to the door panel.
(See Figure 4)
Figure 4
0721 IH-7008