Waste Disposal - GYS GYSDUCT EXTRACTOR Manual De Uso

Operating manual
• Material conforms to UK requirements.
• The UK Declaration of Conformity is available on our website (see cover page).

WASTE DISPOSAL

• This material is subject to separate collection. Do not dispose of in domestic waste.
EN 60335-2-69
The dust compartment should be emptied when necessary, but also after each use.
For dusts with an ignition energy of less than 1mJ, additional restrictions from labour legislation may
apply.
Type 22 units are not suitable for the extraction of dusts or liquids with a high explosion risk, or mix-
tures of combustible dusts and liquids.
CAUTION - Use only accessories approved by the manufacturer for use with the Type 22. Use of
other accessories may cause an explosion hazard.
CAUTION - Use only accessories approved for use with the ESD protected area type. Use of other
EN 60335-2-69
accessories may cause electrostatic discharge.
The appliance should only be operated when all filters, including the engine cooling air filters, are in
place and undamaged.
Dust extractors of the electrostatically protected area type are suitable for connection to dust-produ-
cing appliances in electrostatically protected areas It must be ensured that no ignition sources are
drawn in. Conductive parts of appliances, including extractor hoods and conductive parts of Class II
appliances, must be electrostatically grounded. Electrostatic earthing can be achieved through the
dust extractor or through an independent electrostatic earthing device.
Type 1 and Type 2 ESD protected dust extractors are not suitable for use in equipment where ignition
sources are produced.
PNEUMATICS
The inlet air system pressure must be less than or equal to 10 bar.
A higher pneumatic pressure than recommended can alter the operation of the product, with
a significant loss of suction. In this case, it is necessary to check the pressure at the pro-
duct inlet and on the suction system, located inside the product. (Setting 4 bars max).
A malfunction of the suction system can occur when the bag is full or completely blocked. In this case,
the full bag must be removed and replaced by a new one. For the bag, the manufacturer's recommen-
dations must be followed.
SANDING MACHINE
A pneumatic sander (not included) with a Ø32 mm suction nozzle connects to the hoover. It can also be connected to
the pneumatic network via the automatic nozzle included in the suction hose.
WARNING
The following indications:
1. Before use, read the instructions
2. Connect the hoover's ground clamp to the bodywork to be sanded. (The suction and circulation of dust generates
static electricity).
3. Disconnect the pneumatic power supply before changing the bag.
12
Translation of the original
instructions
GYSDUST EXTRACTOR