GYS GYSDUCT EXTRACTOR Manual De Uso página 13

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 23
Operating manual
The dust bag should avoid contact with flames or sparks.
FEATURES OF THE HOOVER
Mobile pneumatic hoover for explosive dusts deriving from sanding or similar operations, designed for connection to a
pneumatic tool.
Depression
Air flow
Air consumption
Adjustable suction pressure
Suction cable length
Suction cable diameter
Dust bag capacity (included)
Dimensions
Weight
FITTING THE DUST BAG (058880)
WARNING: during this operation, explosive atmospheres and dust deposits may be formed; avoid
introducing potential sources of ignition such as: mechanical sparks, electrical parts, hot surfaces,
flames, hot gases, electrostatic charges in the vicinity of the device. Follow the internal standards
for behaviour in the presence of potentially explosive atmospheres according to the Atex Directive
2014/34/EU.
• Check, at least at the end of the working day, that the dust bag inside the hoover is full.
• The maximum capacity of the dust bag is 7 kg and 20 l volume: do not exceed this limit!
• In the event that the removed bag shows tears, proceed with care and following the internal standards of behaviour
in the presence of explosive atmospheres in accordance with the Atex Directive 2014/34/EU.
• Do not use the same dust bag more than once and use ONLY the GYS dust bag with code 058880.
• Spare bags should be stored in a dry place.
• For disposal, act in accordance with the law and internal standards of behaviour for handling explosive dusts.
Steps for fitting the dust bag
1 - Carry out this operation with the metal clamp connected to the earth circuit of the installation.
2 - Close the compressed air supply valve on top of the hoover.
3 - Disconnect the quick disconnect power connector on the back of the hoover before opening the rear cover. Use the
flush latches to open the bonnet.
4 - Unhook the flange of the dust bag from the suction port, close the dust bag with the cap provided to prevent dust
from escaping from the bag during transport. Carefully lift the dust bag and place it in a designated area within the
ATEX installation.
Translation of the original
instructions
Features
GYSDUST EXTRACTOR
1 150 mm H2O
600 l/min
340 l/min
5 bar max
5 m
Ø 29 mm
7 kg
350 x 800 x 400 mm
21 kg
ATEX Standard
Group II
Category 3
13

Publicidad

Tabla de contenido
loading

Tabla de contenido