GBS Elettronica Puma Instrucciones Operativas página 6

All manuals and user guides at all-guides.com
If you feel most of keys on the remote control work good
enough, you can save the code by pressing
the device key (e.g. TV) to finish the Manual Search.
Remark: The Manual Search will be automatically terminated
if no entry within 30 seconds.
D. Set up by Learning
The LEARNING function is used to supplement the
preprogrammed codes. The standard code list may
provide most of functions needed, but you can add a small
number of additional functions on it. Or you can
add a new code from a original remote control which is
shortage in the code list.
In learning mode, you must prepare a another original remote
control from where you will take the codes.
Please use fresh batteries for both the Learning Remote Control
and the Original Remote Control.
1.Press down and hold the Learn key and press the device
what you wanted to learn(e.g. DVD), then
release the both pressed keys. The LED on your new remote
control blinks and then the remote control is
in learning mode for DVD codes.
2. Press and release the target button which you want to learn
(e.g.POWER), the LED lights up.
3. Point the original remote control to the receiver LED(as the
same as it's transmitter LED) on your new
remote control, the both remotes facing each other by
approximately 30mm apart.
4. Press and hold the source button on your original remote
control (e.g.POWER) until the LED on your
new remote control blinks 2 times and lights up 2 seconds, then
blinks again. (That means you have
learnt POWER singnal from the original remote,and you new
remote control is in learning again for next
learning.) If there is a learning problem, the light blinks 4 times
and lights up for 2 seconds then blinks,
(That means you failed to learn POWER singnal from the
original remote, and your new remote control
is in learning again for next learning.)
5. Repeat Step 2 to 4 to learn more bottons.
Remark:
1. If you want the learning mode to be exited, Press and release
Device key.
2. In learning mode .you must be less than 30 mm between 2
remotes, and the 2 remotes must be put in a
straight line.