Power - Wacker HAL 300 Manual De Operación

Wacker HAL 300
3.8

Power

3.8.1
3.8.2
3.8.3
wc_tx000803gb.fm
All manuals and user guides at all-guides.com
Laser battery
The laser has a NiCad rechargeable battery that should be charged for
15 hours before first use.
Charging the battery
Remove the charging connector cover on the side of the laser. Insert
the charger plug and fully engage the threads.
Plug the charger into an electrical outlet (110 volts or 230 volts,
depending on charger and country).
Charge for 15 hours. When the charger is plugged in, a red light will
illuminate on the charger.
The laser can be charged while working. If electricity is available on the
job site, simply plug in the charger and keep working.
For optimum life of the battery, it is recommended to charge the battery
after fully discharged. To assure battery life, do not charge over 20
hours.
Note: Although the laser is waterproof, do not charge it while it is in
water or submerged.
EN-12
Operation