Operating Console Functions; Switching On / Off; Emergency Stop; Joystick Operation (Driving And Braking) - Vermeiren SE09 Instrucciones De Uso

EN
NL
4

Operating console functions

The operating console enables you to control all driving components as well as the motors to
adjust your body position. For your own safety, and to prevent that the wheelchair gets damaged,
movements are monitored by the electronics. This may result in block of movement, speed
decrease or complete stop.
4.1

Switching ON / OFF

Once the SE09 attendant console is switched on, the regular console will automatically
switch off and vice versa. It is not possible to use both consoles at the same time.
Put the joystick in the neutral (central) position before pressing the ON/OFF button.
If the console is switched on with the joystick out of the neutral position, the wheelchair will
not drive. Release the joystick (return to neutral) within 5 seconds to unlock the drive. If the
joystick is not released within 5 seconds, the fault turns into a Module fault which is
indicated by the red blinking LED in the ON/OFF button. The wheelchair will not drive. To
clear the Module fault, release the joystick and switch the operating console OFF and then
ON again.

To switch the operating console ON, press the ON/OFF button once (see part 1, Figure 1).
The LED (status indicator) in the ON/OFF button goes on. When it turns green, the operating
console is ready for operation.

To switch the operating console OFF when it is ON: press the button once.
The operating console will power down and the status indicator goes out.

4.1.1 Emergency stop

If you need to stop a driving or body-positioning movement quickly, press the ON/OFF button to
perform an EMERGENCY STOP. The wheelchair will come to a halt quickly.
4.2

Joystick operation (driving and braking)

Operating the joystick in a specific direction will move the electric wheelchair in that direction. The
speed of movement depends on the displacement of the joystick. If the joystick is pushed/pulled
to maximum displacement, the speed will be maximal (within the selected drive mode).
By moving the joystick to its central position (neutral) during driving, the
brakes will start working until the wheelchair stops:
 For gradual braking, move the joystick slowly
 For a quick stop, release the joystick; the wheelchair will stop as
quickly as possible.
Make sure that the joystick is in neutral (central) position when pressing the on/off button,
otherwise the electronics will be locked.
After switching the operating console ON by the ON/OFF button, the joystick has to stay in
the central position for at least five seconds. The console has been programmed this way
for technical and safety reasons. If the joystick and ON/OFF button are activated at the same
time, the steering unit is locked and will only unlock after switching completely OFF.
Joystick movements
6
SE09
2022-01
Operating console functions