Important Safety Information; Rear Wheels - Expondo STAMOS S-WECA-1 Manual De Instrucciones

1. IMPORTANT SAFETY INFORMATION

The cart is designed to carry one gas cylinder for use with a MIG, TIG or other wel-
ding or cutting power source. Use caution when handling compresses gas cylinders
and only use in the upright position. Use the cylinder security chains that are supplied
to secure the compressed gas cylinder to the cart.
Never attempt to weld on the compressed gas cylinder.
The cart can be easily maneuvered by grasping the top shelf and handle to the desired
position. Use caution when moving the cart since the weight of the compressed gas
cylinder and the welder could cause the load on the cart to be top heavy.
Never pull the cart with the MIG welder gun, torches or cables; this could cause the
cart to tip or the power source to be pulled off the cart. Damage to the cart, power
source, and compressed cylinder could occur.
Follow gas cylinder supplier's and gas supplier's safety instructions at all times.
2. ASSEMBLY INSTRUCTIONS

2.1. REAR WHEELS:

Slide axle through support tube on bottom of base plate.
Fit wheel onto axle, slip over the end of axle.
Insert cotter pin into hole at the end of the axle and bend in place.
Place protective cap over axle end and pin.
Repeat the above for other wheel.
2.2. FRONT CASTER WHEELS:
Align the swivel caster wheels with the 4 holes located on the front section of the
base plate.
From the top of the shelf insert the bolt through the hole and secure it with the nut
on the bottom side.
Repeat the above for other side.
Make sure all nuts and bolts are tight.
Rev. 03.03.2017
EN
10
2.3. BACK VERTICAL SUPPORT PANEL:
Align the holes in the bottom and the sides of the back vertical support panel with
the holes in the sides and base plate.
Insert a bolt through center hole of the back vertical support panel and the bottom
base plate and secure with a nut.
From the outside of the base plate, insert a bolt through left hole of the back vertical
support panel and secure with nut.
Repeat the above on the other side.
Hand tighten bolts and nuts.
2.4. LEFT SUPPORT RAIL & RIGHT SUPPORT RAIL:
Align left bottom support rail on the front left side of bottom base plate.
From the outside of left support rail, insert bolt through each hole and secure on the
inside with a nut.
Repeat the above on the right side.
Hand tighten bolts and nuts.
11 11
EN
Rev. 03.03.2017