Küschal ULTRA-LIGHT Manual Del Usuario página 45

1. Attach the front straps above the castor supporters as
shown in the two figures above (see location of the
attachment labels).
2. Attach front straps to the rail system referring to best
practice recommended instructions from the safety
belt manufacturer.
3. Release the parking brakes and apply tension front
straps by pulling the wheelchair backwards from the
rear.
4. Re-apply the parking brakes.
Rear side tie-down positions for snap hooks:
1583566-D
1. Attach the snap hooks to the rear frame right above
the adapter plate as shown in the two figures above
(see location of the attachment labels).
2. Attach rear straps to the rail system referring to best
practice recommended instructions from the safety
belt manufacturer.
3. Tighten the straps.
IMPORTANT!
– Make sure that the snap hooks are covered
with slip resistant material to avoid laterally
slipping on the axle.
IMPORTANT!
– Check the plungers are fully engaged on both
sides and located in the same position of the
cut-out section of the rail.
– Make sure that the angle between the rails
and the straps lies between 40° and 45°.
Fastening the 3-point passenger restraint system
Transport
45