Craftsman F1725 Manual De Usuario página 4

AA
BB
CC
Front
Flanges
point out
Back
• Square the unit and wrench tighten all fasteners.
STEP 5:
• Position frame assembly on workbench top, (D) as desired.
Note: The back of the work bench frame must be at least 1-1/2
inches (38 mm) from the back of the workbench top (D).
• Mark centers of mounting holes.
• Move workbench assembly for access.
• Drill 1/8" pilot holes 1/2" deep in mounting hole locations.
• Reposition workbench assembly on workbench top (D).
• Attach using (DD).
Note: Additional fasteners may be used to attach workbench top
through holes in side support if desired. (Not supplied)
1-1/2 inches
38 mm
All manuals and user guides at all-guides.com
B
CC
BB
DD (15) 8'
DD (11) 6'
• Place the workbench in its upright position.
• Position (C) centered against back of workbench top (D), with
flange underneath.
• Mark center of mounting hole locations using the holes in
flange of (C) as a template. Make sure (C) does not move.
• Remove (C) for access.
• Drill 1/8" pilot holes 1/2" deep in mounting hole locations.
• Reposition (C) on workbench top (D).
• Attach using (DD).
AA
Flange
underneath
Leveling Foot Adjustment
• Adjust leveling foot to
desired position with flat
head screwdriver or 7/16
open end wrench as shown.
• Periodically the surfaces should be cleaned with a mild
detergent and water.
Grease and oil can be removed with most standard cleaning
fluids. For safety, use a nonflammable cleaning fluid.
Auto wax will preserve the unit's luster finish. Apply the wax as
to a car. The wax will also help protect the unit against
scratches.
4
DD
OPERATION
MAINTENANCE
C