- For better cooling performance, it is recommended to put ice pack in the water tank.
- After refilling the water tank and placing the ice packs, close the water tank, connect to
power supply and turn it on.
-
To drain water from the tank, remove the rubber plug from the drain hole on the side. After
draining the water, cover the hole with the cap.
Caution: Running the unit with inadequate water may cause pump failure.
CLEANING AND MAINTENANCE
• Before cleaning the unit, switch it to off position and unplug from the power supply.
• Use a damp cloth to remove dirt and dust from the outer surface.
• Never use corrosive elements or any chemicals to clean this product.
• Remove the filter and honeycomb filter from its shell for cleaning.
• Wash the filter in a mild detergent and warm water solution. Then rinse in clean water.
• Use a brush and water to clean the honeycomb filter.
• The cleaning frequency for the honeycomb filter depends on local air and water conditions. In areas where the
mineral content of water is high, mineral deposits may build up quickly on the honeycomb filter and restrict air flow.
Draining the water tank and refilling with fresh water at least once a week will help to reduce mineral deposits. If
mineral deposits remain on the honeycomb filter, then it should be removed and washed under fresh water. The
honeycomb filter should be cleaned every two months or sooner, depending on the frequency of mineral deposits
or dust accumulation.
• Do not run the unit in
been standing in the tank for an extended period of time.
• When the product is not in use, store the unit in a dry place out of direct sunlight.
All manuals and user guides at all-guides.com
mode with stale water in the tank. Empty the tank and refill it with fresh water if water has
24