All manuals and user guides at all-guides.com
OBJ_DOKU-153232-006.fm Seite 15 Dienstag, 22. November 2016 11:16 11
IMPORTANT!
Please read all information carefully.
These instructions for use do not replace the user manual of the
electrosurgical unit used! Read the user manual of the electro-
surgical unit and ask Erbe or your distributor in case of doubt!
1
Normal Use
The electrodes are intended for monopolar cutting with the Erbe
handle Art. No. 20190-041.
The loops are intended for the Erbe conization electrode Art.
No. 20191-075.
Erbe recommends the use of Erbe electrode handles. If a handle
from another manufacture is used to operate the HF electrode,
please observe the following: The joint from HF electrodes to
handles of other manufacturers is not standardized. The handle
of another manufacture, although it may appear to fit the Erbe
HF electrode, may have different dimensions and tolerances, a
different type of insulation, etc. Such differences hold risks for
patient and staff. Erbe Elektromedizin is glad to provide more in-
formation as required.
2
Maximum electrical capacity
The maximum electrical capacity of these products is:
• 500 V
p
15