Application Example - BGS technic 9414 Guia De Inicio Rapido

INSTALLATION
When the tool is relaxed, the position of the clamping
device is as shown in the figure on the right.
Turn the tension screw clockwise for tensioning the
chain and pulling down the wishbone.

APPLICATION EXAMPLE 1

Pull down the joint out of the wheel bearing
housing
Loosen the joint clamping screw from the bearing
housing. Turn the tensioning screw from the wishbone
lever tool clockwise and separate the joint from bearing
housing. The wishbone can remain in this position
during repair.
APPLICATION EXAMPLE 2
Separate the wheel bearing housing from spring
strut.
Loosen the spring strut clamping screw (wheel bearing
housing). Turn the tensioning screw from the wishbone
lever tool clockwise and pull down the wishbone to
separate the wheel bearing housing from spring strut.
The wishbone can remain in this position during repair
work.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed