INTENDED USE
This wishbone lever tool is designed for comfortable, secure push down and hold-down of wishbone
during renewing of the wheel bearing, disassembling of the drive shaft and repairing of the spring
strut, etc.
ATTENTION
Read and understand all instructions and information in this manual.
Failure to follow the instructions and information below may cause serious injury and damage.
Keep the manual for future reference in a safe and dry place.
SAFETY INSTRUCTIONS
• Follow the manufacturer's specifications. This manual is supposed to inform you about the tool
itself and does not replace specific servicing handbooks.
• Keep children and unauthorized persons away from the working area.
• Do not let children play with this tool or its packaging.
• Ensure the working area has adequate lighting
• Keep working area clean and tidy, dry and free from unrelated materials
• Do not allow untrained persons to use this tool kit
• Always wear eye protection and gloves when working with the tool.
• Check the tool for damage before use, do not use the tool if it is damaged.
• Ensure that the chains are well secured at suitable points.
• Do not overload the wishbone lever tool, the maximum pulling force is 500Kg.
INSTALLATION
Install the tool as shown in the picture.
1. Insert the hook in opposite position of the chain to a suitable point.
2. Loosen the tensioning screw (1) of the tensioning device.
3. Attach chain (2) to the wishbones suitable points.
4. Tension the chain (2) by turning the tensioning screw (1).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Wishbone Lever Tool
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 9414
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed