Conservation Charge; Charging Battery Pack - Starmix ASC 55 Instrucciones Para El Manejo

en ENGLISH
Pull out the mains plug immediately
if the battery charger starts to smoke
or flames emerge!
Do not insert objects into the ventila-
tion slots on the battery charger –
there is a danger of electric shocks
and short circuits!
Do not use faulty battery packs.
In areas with high metal dust expo-
sure do not load any battery packs
with AIR COOLED chargers.
4. Overview
See page 4.
1 Battery pack (not in scope of delivery)
2 Sliding seat
3 Operation display
4 Warning display
5. Commissioning
Before plugging in, check to see that
the rated mains voltage and mains
frequency, as specified on the rating
label, match your power supply.
Devices such as this one, which generate
direct current, may have an effect on basic
residual-current circuit breakers. Use type F
or better, with a release current of max.
30 mA.
Before commissioning the charger, ensure
that the air slots are free. Minimum
distance to other objects is 5 cm.
5.1 Self-test
Insert mains supply plug.
The warning display (4) and the operating
indicator (3) light up one after the other for
approx. 1 second and the installed fan runs
for approx. 5 seconds.
6. Use

6.1 Charging battery pack

Push the battery pack completely to the
stop on the sliding seat (2).
10
The operating indicator (3) flashes.
Note: To have the charge level displayed on
Li-ion battery packs, first take the battery
pack out of the charger and then press the
button on the battery pack.

6.2 Conservation charge

Once the charging process has finished, the
battery charger automatically switches to
conservation mode.
The battery pack can remain in the battery
charger and is therefore always ready for
use.
The operating display (3) lights up
continuously.
7. Fault
7.1 Warning display (4) lights up continu-
ously
Battery pack is not charged. Temperature
too high/too low. When the temperature of
the battery pack is between 0 °C and 50 °C,
the charging process begins automatically.
7.2 Warning display (4) flashes
• Battery pack is defective. Remove the
battery pack immediately from the
charger.
• The battery pack was not pushed correctly
onto the sliding seat (2). See section 6.1.
8. Repairs
Repairs to the charger must only be carried
out by qualified electricians.
If the mains connection cable of this tool is
damaged, in order to prevent endangering
personnel and property it must be replaced