Porter Cable PCSRW4800 Manual De Instrucciones página 8

holes and tabs. Too much force may damage the interlock between the crossbeam (4) and
upright frame. (Fig. D)
3. Using the methods listed above, install another crossbeam (4) to the opposite side of the upright
frames, parallel to the first crossbeam (4) you installed. Make sure both crossbeams (4) are at
the same level.
4. Repeat the previous steps for installing crossbeams spaced four slots from the top of the rack
upright frames. (Fig. E)
Fig. C
4
LOCKING
PIN HOLE
PART 2: DRAWER ASSEMBLY (FIG. F-I)
NOTICE
This fold up drawer (19) is designed to be placed under a shelf so that the shelf may act as the
drawer top.
1. Open the fold up drawer (19) and install the drawer pull (20) by slipping it into the tabs on the
inside of the fold up drawer (19) front. Secure it using the provided drawer carriage bolt (22) and
nut (23) in the top corners of the fold up drawer (19). Make sure the nuts (23) are inside of the
fold up drawer (19). (Fig. F)
2. Using the remaining drawer carriage bolts (22) and nuts (23), secure the top corners of the fold
up drawer (19) on the opposite side of the drawer pull (20). (Fig. G)
NOTE: Ensure that the drawer slides open to the front of the rack.
3.
Install the mounting brackets with the drawer slides onto the rack with six slots spaced from the
top of the vertical beams (1). This will be directly underneath the top set of crossbeams (4) that
were installed previously. This is done by positioning the mounting bracket with drawer slides
(21) on the inside edge of the rack uprights. Slide down the mounting bracket with drawer slides
(21) to seat them properly. Ensure both brackets are level with one another when tightening the
mounting bracket hardware. (Fig. H)
4. NOTE: Ensure mounting brackets with drawer slides (21) are level before installing the fold up
drawer (19). Have a helper assist with the install of the fold up drawer (19) onto the
drawer slides (21).
Slide the guides on the fold up drawer (19) into the rails on the mounting bracket (21): there
should be a distinct click when the guides have seated properly. (Fig. H)
5. To secure the brackets (21) to the rack's uprights, install the locking pins (10) into the mounting
bracket with drawer slides (21). (Fig. I)
Fig. F
22
20
Fig. D
Fig. G
23
19
Fig. E
Fig. H
REAR OF
DRAWER
19
8
21