Storing The Trimmer After Use - IRONSIDE GARDEN IGHT45-2 Manual De Instrucciones

Maintenance
Always disconnect the plug from the power socket before commencing any work on the
machine.
Important: Always clean and oil the blades after prolonged use of the hedge trimmer. This will greatly
affect the life of the equipment. Damaged cutting units must be properly repaired immediately. Clean
the blades with a dry cloth, or in case of heavier dirt with a brush.
Attention: Danger of injury! Oiling of the blades should ideally be carried out using an
environmentally friendly lubricant (Fig. 3).
Sharpening of the blades
The blades generally do not need servicing and do not require re-sharpening if used correctly.
Changing the blades
Only correct installation of the blades will guarantee problem-free operation and function of the above
mentioned safety feature. Changing of the blades should therefore only be carried out at a specialist
workshop.

Storing the Trimmer after Use

The hedge trimmer must be stored such that there is no danger of injuries being caused to
persons by the cutting blades!
Important note: The blades should be cleaned after each use. This will considerably increase the
service life of the device. Please use a lubricator that is not harmful to the environment. Then put the
shears in the storage bag.
Technical Data
Operating Voltage
Nominal Frequency
Nominal consumption
Cutting movements
Cutting Length
Cutting Thickness
Unit weight
Noise Power Level
Noise Pressure Level
Vibration
All manuals and user guides at all-guides.com
505009
230 V
50 Hz
450 W
1600min
450 mm
16 mm
2.6 kg
104dB(A)
83dB(A)
3.307 m/s
505016
~ ~
230 V
50 Hz
550W
-1
1600min
600 mm
20 mm
2.7 kg
104 dB(A)
83 dB(A)
2
3.307 m/s
-1
2