Range Of Use - NERI E1 Informative Note

UK - INFORMATIVE NOTE
Read this informative note through carefully prior to use and prior to any maintenance
p
work. The purpose of the information contained herein is to assist and direct the user in
choosing and using the PPE. Neither the manufacturer nor the distributor can be held
liable for an incorrect use of the PPE. This informative note must be kept for the duration of the PPE.
The CE mark means that these helmets are personal protective equipment conforming
A
to the essential health and safety requirements set forth in the (EU) Regulation 2016/425
and have been certified under EN 397:2012 + A1:2012 by the notified body: ALIENOR
CERTIFICATION - ZA du Sanital - 21 Rue Albert Einstein - 86100 CHATELLERAULT - France - n°
2754.

RANGE OF USE

Protective helmets for industry are to protect the top part of the head of the wearer from falling
objects and resulting cerebral lesions and/or fractures of the skull. The helmets are, in fact, designed
to absorb the impact of a knock by either destroying or partially damaging the top of the helmet or
the strap. Even if such damage might not be instantly visible, any helmet subject to a bad knock must
be replaced immediately.
Important note: This level of protection is applicable only for the part of the wearer's body for which
it has been designed – the head. The helmet provides no protection for the neck or any other part of
the head it does not cover. To protect the other parts of the body adequately, other suitable protection
equipments must be worn (PPE).
MARKING IDENTIFICATION
MANUFACTURER'S IDENTIFICATION
A
CE MARK
EN 397:2012
EUROPEAN STANDARD
+ A1: 2012
51-63 cm
RANGE OF HEAD SIZES
E1
HELMET MODEL
ABS
IDENTIFICATION OF THE CAP MATERIAL

MONTH AND YEAR OF MANUFACTURE
HOW TO WEAR AND ADJUST THE HELMET
For the helmet to give proper protection it must be adapted and adjusted to the size of the wearer's
head. Before putting the helmet on, turn the ratchet knob under the nape anticlockwise until the band
is as wide as it can be. Put the helmet on and adjust the strap.
The helmet must always be low at the front to protect the forehead.
Adjust as follows:
- adjust the length of the band by turning the ratchet knob clockwise until it is the size wanted.
Do not tighten too much.
- vary the height of the vertical fit, choosing one of the 4 positions of the snap-in pin mechanism.
This guarantees an excellent fit to the shape and size of your head, corresponding to a circumference
ranging between 51 and 63cm.
When the internal strap is adjusted properly it ensures that the helmet sits firmly on the head,
5