Uline H-8520 Manual De Instrucciones página 2

Figure 2
Figure 3
Long Strut
Short Strut
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
ATTACH LEGS
1. Place the bottom tray (with casters) upright. Lock the
swivel casters. (See Figure 2)
2. Attach leg to the outside of tray with four 5/16 x 1/2"
bolts and four 13 mm nuts.
3. Repeat Step 2 for the remaining three legs.
4. Completely tighten all bolts.
ATTACH STRUTS
1. Attach long strut to the inside of the legs with two
5/16 x 1/2" bolts and two 13 mm nuts. (See Figure 3)
2. Repeat Step 1 for the second long strut.
3. Attach short strut to the inside of the legs with two
5/16 x 1/2" bolts and two 13 mm nuts.
4. Repeat Step 3 for the second short strut.
5. Completely tighten all bolts.
ATTACH CHEST
1. Place chest inside legs. Make sure that holes at the
top of the legs align with holes on chest.
(See Figure 4)
2. Choose which side to install handle. On the side
without the handle, thread four 5/16 x 1/2" bolts
and four 13 mm nuts to each corner. On the side
where handle will be installed, only thread two
5/16 x 1/2" bolts and two 13 mm nuts on top, leaving
the bottom holes open.
NOTE: Position leg so two holes near middle are
closer to bottom tray.
NOTE: Ensure that bolt heads face outward.
NOTE: Ensure that the strut lip faces inward and
downward.
NOTE: Ensure that the strut lip faces inward and
holes face upward.
0521 IH-8520