Important Safety Instructions; Installation Instructions - IKEA UPPSPEL Manual Del Usuario

Ocultar thumbs Ver también para UPPSPEL:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
IMPORTANT
SAFETY
INSTRUCTIONS
When using an electrical furnishing, basic precautions should
always be followed, including the following:
Read all instructions before using the product.
DANGER
To reduce the risk of electric shock:
Always unplug this furnishing from the electrical outlet before
cleaning.
WARNING
To reduce the risk of burns, fire, electric shock, or injury to
persons:
1. Unplug from outlet before putting on or taking off parts.
2. Close supervision is necessary when this furnishing is used
by, or near children, invalids, or disabled persons.
3. Use this furnishing only for its intended use as described
in these instructions. Do not use attachments not
recommended by the manufacturer.
4. Never operate this furnishing if it has a damaged cord or
plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return the furnishing to a
service center for examination and repair.
5. Keep the cord away from heated surfaces.
6. Do not use outdoors.
7. Do not operate where aerosol (spray) products are being
used or where oxygen is being administered.
8. The table must not be overloaded – maximum load is
70kg/154lbs
An electro-mechanically height adjustable work-surface with
control interface to adjust height up and down.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved
by a person responsible for their safety.
Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without
supervision.
SAVE THESE INSTRUCTIONS
4
Electrical sit and stand desk
Advice and instructions for UPPSPEL
Input:
100-120VAC, 50/60Hz
Standby power consumption:
<0.1 W.
Sound level:
Lower than 55 dB(A).
Height setting interval:
72-120 cm/28.3-47.2 inch.
Maximum load:
70kg/154lbs.
Temperature interval at usage:
+50 up to +104 °F/+10 °C up to + 40 °C.
Temperature interval at storage:
0 up to 158 °F/-18 °C up to 70 °C.
Humidity:
20% up to 80% at 104 °F/40 °C.
Power supply unit:
24.0V DC, 240 W.
This appliance shall only be used together with the
included power supply unit.
Every person who is responsible for this table at installation or
employment of the table in daily use or in service and repair
work should carefully read these instructions. Keep these
instructions close to your sit/stand table.

Installation instructions

• The table is assembled according to separate assembly
instructions.
• Connect the electrical cable to a power source.
NOTE! The electrical cable must have full mobility.
• The table is now ready for use. The motors stop
automatically when the table reaches its lowest and highest
position respectively.
Usage
• The table shall only be used as a gaming table with the
possibility to continuously adjust the working height
between sitting and standing position.
• The table shall only be used indoors and in dry premises
(office environment or similar).
The table must not be overloaded - maximum load is
70KG/154lbs. The system may be run continuously for a
maximum of 2 minutes. Afterwards, the motors must stand
idle for approx. 18 minutes before they can be used again.

Publicidad

Tabla de contenido
loading

Tabla de contenido