LUTEC BT77P Manual De Usuario página 15

17. The power supply unit does not work!
A: Check whether the cable is plugged in correctly. The arrow on the charging cable must point to the
exterior of the Car Kit! During charging, the red and green control lamps on the charging cable must
light up. Check also the connection of the charging cable to the car.
18. My Car Kit is defective! What else do I need to return?
A: Please contact our service hotline! The service assigns a RMA number, which you will need for
dispatching. Please return the defective Car Kit with all accessories.
19. How long does it take to charge the Car Kit?
A: Before using the Car Kit for the first time, it needs to be charged for 6 hours. After that a complete
recharge cycle will take only max. 3 hours. After the recharge cycle is completed, the LED indication
changes from red to blue.
20. How long is the standby-time of the Car Kit?
A: It is difficult to recommend general guidelines, since the standby-time depends strongly on the used
mobile phone as well as on the distance between Car Kit and
21. Is it important that the Car Kit is switched off during charging?
A: Also during recharging, you may use the Car Kit with mains connection. Note that recharging will take
longer in this case.
Warning: Make sure that the device will not disturb or distract you while driving. The sun visor is
the best place for the Car Kit, allowing you to phone without being distracted while you can
focus on the road!
22. The Car Kit cannot be recharged!
A: Please get in touch with our customer service:
23. How does pairing work?
A: Before performing pairing, you need to enable the pairing mode of the Bluetooth Car Kit (see operating
instructions). The red and blue LED indicators start to flash alternately. Switch on your mobile phone
and enable the pairing mode, as described in the manual of the mobile phone.
Then, start to pair your Bluetooth phone and the Car Kit. If your mobile phone prompts you to enter a
passkey/password/code, enter 0000 and confirm the entry. (Note: The code 0000 is a default PIN code
pre-stored in the Car Kit). This PIN code cannot be modified. If the pairing procedure is completed
successfully, the red and blue LED indicators start to flash.
24. What is the pairing code (also called passkey/password/code)?
A: The pairing code is 0000!
25. My mobile phone cannot be paired with the Car Kit, although it is listed in the compatibility list!
A: Have your mobile phone checked by the relevant manufacturer!
phone.
bt77p@lutec.eu
- 15 -