Remove The Battery Pack; Install The Filter; Remove The Filter; Operation - GreenWorks Pro VU0B01 Manual Del Operario

11.6

REMOVE THE BATTERY PACK

1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
11.7

INSTALL THE FILTER

10
1. Press the latch on the both sides of the top cover
assembly then lift it up.
2. Align the filter with the filter cage.
3. Slide the filter on the filter cage.
4. Turn the filter cap clockwise.
5. Tighten the filter cap.
11.8

REMOVE THE FILTER

1. Press the latch on the both sides of the top cover
assembly then lift it up.
2. Turn the top cover assembly upside down.
3. Turn the filter cap counterclockwise.
4. Slide the filter off.
English
12

OPERATION

Do not handle battery pack, switch, or machine with wet
hands. Do not expose to rain or allow liquid to enter the
motor compartment.
12.1

START THE MACHINE

10
Make sure that the battery doors are locked into place or the
machine will not start.
1. Insert the battery packs or connect to the power source.
2. Turn the switch to the right operate under DC MODE.
3. Turn the switch to the left to operate under AC MODE.
Leave a gap at the tip of the nozzle opening to allow air
inflow when you vacuum large quanties of liquids.
When the collection tank reaches the maximum capacity,
the suction action will stop. When this happens, turn off the
machine, disconnect from power supply and turn the drain
cap to drain the liquid.
12.2

STOP THE MACHINE

1. Turn the switch to off position.
9
WARNING
NOTE
NOTE
NOTE
EN