Uline H-2112 Manual De Instrucciones página 2

5. Attach casters to exposed end of each fork pocket.
(See Figure 4)
a. Set one 3 ⁄ " flat washer above each hole in fork
8
pockets.
b. Insert one ⁄ x 1¼" bolt through washer,
3
8
corresponding bolt hole and bolt hole in caster
plate.
c. Slide another 3 ⁄
8
of bolt. Add 3 ⁄ " lock washer and secure with
8
nut.
d. Tighten connections with
WARNING! Never crawl or stand under an
elevated hopper. Limit exposure to reaching
under hopper to fasten hardware.
Bolt
Flat Washer
Lock Washer
PAGE 2 OF 6
CASTER INSTALLATION CONTINUED
" flat washer over threaded end
⁄ " wrenches.
9
16
Flat Washer
Nut
6. After installing two casters, slowly lower forks and
disconnect safety chain.
7. Back lift truck away until forks are free of hopper's
fork pockets.
8. Drive lift truck to opposite end of hopper and repeat
Steps 1–5.
9. After installing casters, slowly lower forks and
disconnect safety chain.
3 ⁄ "
8
10. Back lift truck away until forks are free of hopper's
fork pockets.
WARNING! Adding casters will reduce the
rolling load capacity of some models.
CASTER TYPE
Steel Casters
Mold-on Rubber Casters
Poly-on Steel Casters
Figure 4
1-800-295-5510
uline.com
CAPACITY (LBS.)
1,200 lbs./caster
600 lbs./caster
1,200 lbs./caster
0621 IH-2112