Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Safety regulations
The Manufacturer declines any responsibility for failure to respect the Safety Regulations and the prevention as described
below.
Furthermore, the Manufacturer declines any responsibility for damage caused by the improper use of the unit and/or
modifications carried out without proper authorisation.
•
Qualified personnel must carry out the installation.
•
During the installation operation, use protective clothing, for example: glasses, gloves, etc. as indicated by 686/89/CEE and
successive regulations.
•
During the installation operate in absolute security, pollution free air and in an area free of obstructions.
•
Respect the regulations in force in the country in which the apparatus is being installed. Specifically relative to its use, and
to the disposal of packing and products used for the cleaning and maintenance of the unit. Respect the recommendations
given by the producers of such products.
•
Before placing in function the unit, check the perfect connection of the various components and the internal parts of the
system.
•
Avoid at all costs human contact with moving parts and contact with the parts themselves.
•
Do not commence with servicing or cleaning of the unit, before the unit has been disconnected from the main
supply.
•
The maintenance and the substitution of damaged or consumed parts must be carried out only by specialised personnel,
following the indications found within this manual.
•
Spare parts must correspond to the requirements specified by Manufacturer.
•
In case of dismantling of the unit, respect the anti-pollution regulations in force.
N.B. The installer and the user of the apparatus must take into account, and solve problems, connected with any other type of risk
that may occur to the unit. For example, risks derived from the entrance of foreign bodies, or risks due to the presence of flammable
or toxic gas.
Preliminary operations
•
Check the perfect condition of the various components of the unit.
•
Control that contained within the packing, there are the installation accessories, and documentation.
•
Transport the packed section as close as is possible to the intended place of installation.
•
Do not place tools or weight on top of the packed unit.
Choosing place of installation
•
Position the unit on a solid structure, that will not vibrate, and is capable supporting the weight of the machine.
•
Position the unit in a point where the condensation discharge may occur easily.
•
Do not position the unit in an area in which flammable gases, acidic or corrosive substances are present. They may damage
various components in an irreparable manner.
•
Allow a minimum amount of free space as indicated in the figure 3. This permits ease of installation and maintenance.
Machine positioning
The unit is equipped with anti-vibration support plates already mounted.
With referement to the figure 4, the following are instructions to fix the unit to its supports :
1.
Carry out the drilling of the ceiling, and fit the four M8 threaded bolts (1).
2.
Position the unit on the four bolts using the supplied fixing plates (6).
3.
Insert anvibrator (2), washer (3) and screw nut (4) and lock nut (5) without blocking.
4.
Install the unit with at least 1° inclination towards the condensate outlet to aid the condensation going out.
5.
Block the unit tightening the fixing bolts.
GB
5
Publicidad
Capítulos
Tabla de contenido
