Pfeiffer Vacuum TPG 366 Instrucciones De Instalación página 4

Installation
Desk-Top Unit
4
Thermal overload!
 Set up the unit so that the admissible maximum ambient temperature (e. g. due to
installation or sunlight) is not exceeded.
 Ensure adequate air circulation!
The following operator panel cutout is required for mounting in an operator panel:
212
198
Fig. 3: Operator panel cutout and mounting
 Guide the device into the operator panel cutout.
– It is advisable to support the device in order to ease the load on the front panel.
 Fasten the device in place with four M3 or comparable screws.
The TPG 366 is also suited for use as desk-top unit. For this purpose, two self-adhesive
rubber feet as well as a slip-on rubber bar are supplied with it.
Thermal overload!
 Set up the unit so that the admissible maximum ambient temperature (e. g. due to
installation or sunlight) is not exceeded.
 Ensure adequate air circulation!
Fig. 4: Usage as a table device
 Glue the rubber feet supplied with the product to the back of the housing base.
 Slip the supplied rubber bar onto the bottom edge of the front panel.
NOTICE
M3 or ø3.5
NOTICE