Technical Specifications - Grizzly EMH 2440 Manual De Instrucciones

GB
proper use. Certain components, such
as the blade are subject to normal
wear and are not covered by guaran-
tee.
• Guarantee is conditional on adherence
to instructions on cleaning and servic-
ing instructions.
• Damage resulting from material or
manufacturing defects shall be rem-
edied by replacement or repair free of
charge.
• Our service centre will also repair parts
not covered by guarantee for a fee.
The service centre will be pleased to
give you a cost estimate.
We can only repair equipment with suf-
ficient postage and packaging by the
sender.
• This requires you to return the non-
dismantled unit together with its
receipt slip and warranty card to our
Service Centre.
We will not accept bulk consign-
•
ments, express or other special
freight where postage has not been
paid for.
• We will dispose of your equipment free
of charge.

Technical specifications

Electric garden shredder ..... EMH 2440
Nominal power intake ........
Nominal voltage .......... 220-240 V~; 50 Hz
Safety class .......................................
Degree of protection .......................... IP24
Idling speed (n) .........................3940 min
Branch thickness ................max. 40 mm**
Volume of collection bag................ca. 60 l
Weight ..............................................12 kg
Sound power level (L
guaranteed ................................107 dB(A)
measured............106 dB(A); K
Acoustic pressure level
(L ) ...................... 98 dB(A); K
pA
78
2400 W,(P40)*
)
WA
= 1 dB(A)
WA
= 3 dB(A)
pA
The sound levels have been determined
in accordance with noise measuring pro-
cess EN 13683:2009-09, appendix F.
* Continuous-operation periodic duty
(40 sec on - 60 sec idle)
** The max. branch thickness that can
be chaffed is dependent on the type of
wood and the quality of the goods be-
ing cut.
For hard wood (e.g. oak/beech
branches), the max. branch thickness
that can be chaffed is less than for
soft wood (e.g. pine/spruce wood).
For dry or knotted wood, the cutting
thickness may also be less.
Noise and vibration values were deter-
mined according to the standards and
stipulations mentioned in the declaration
of conformity.
II
-1