Chicco KEY1X-PLUS Instrucciones De Uso página 28

For removal of the child car seat's fabric cover,
it is fi rst necessary to unthread the straps:
- Press the strap adjustment pushbutton
(Fig. 16). Simultaneously, take hold of the
two harness straps just below the shoulder
pads;
- Undo the harness straps by pressing in the
red pushbutton on the buckle (Fig. 17);
- Slide out the two strap ends from the belts
plate at the rear (Fig. 28);
- Pull the harness straps out from the front
so that they thread out completely from
the head rest and shoulder padding (Fig.
29);
- Slip off the headrest cover and the child car
seat cover.
To reassemble the child car seat's fabric cover
and straps, act as follows:
- Replace the headrest cover and the child
car seat cover:
- Push the two ends of the harness straps
fi rst through holes in the seat cover (Fig.
30), then through the shoulder padding and
then through headrest holes (Fig. 31)
- Slide the two strap ends back onto the
plate (Fig. 32); check to make sure that
both the plate and the strap ends are in
position exactly as illustrated in Fig. 33.
WARNING! Check that the straps/belts are
not twisted anywhere.
WARNING! Check that the plate is always
correctly positioned in its appropriate housing
underneath the seat base frame (Fig. 34).
Cleaning the plastic and metal parts
Clean the plastic or varnished metal parts us-
ing only a soft, damp cloth.
Never use abrasive detergents or solvents.
The child car seat moving parts must never be
lubricated.
Inspecting the condition of components
It is recommended to regularly check the con-
dition of the following components for any
wear and tear:
• Fabric cover: check that the padding has
not been torn out or is bursting out of the
seams. Check the condition of the seams:
they must always be completely secure.
• Straps: check that there is no irregular
wear and fraying of the woven straps, with
evident thinning out of adjustment strap
thickness, or of the lap harness strap, the
shoulder straps, as well as in the area of the
All manuals and user guides at all-guides.com
28
belt adjustment plate.
• Plastic parts: check all plastic parts for wear
and tear, damages or fading.
WARNING! In the event that the child car seat
is evidently deformed or very worn, it must be
replaced: it may no longer conform to the
original safety standards.
Storing the Product
When it is not fi tted into the car, it is recom-
mended that the child car seat is stored in a
cool, dry place, far from heat sources and dust
contamination, as well as humidity and direct
sunlight.
FOR FURTHER INFORMATION,
PLEASE CONTACT:
Chicco UK Limited
Prospect Close
Kirkby in Ashfi eld
Nottinghamshire
NG17 7LF
Customer Services Tel: 01623 750870
www.chicco.com