Dell M8428-k Guía De Introducción página 7

Modify the converged network switch IP address
By default, the IP address for the converged network switch is configured as 10.77.77.77 with a default Ethernet
subnet mask of 255.255.255.0. The default gateway is 0.0.0.0.
Reset the IP address using three methods. If the IP values are set using any of these methods, the IP values are
stored on the switch module.
•
Blade Server Enclosure CMC CLI.
•
Blade Server Enclosure CMC graphical user interface (GUI).
•
Dell M8428-k command line interface (CLI).
After modifying the switch module's IP address and domain name (if the switch module is in full fabric mode), we
recommend that you cable all external ports to fabric connections before bringing the switch module online.
ATTENTION
Do not connect the switch module to the internal network until the IP address is correctly set for your Ethernet network
requirements.
NOTE
It is recommended that you set the IP address using the Blade Server Enclosure CMC GUI application because this
enables centralized management of the converged network switch.
Using the CMC CLI to set the IP address
Use the following steps to connect modify the converged network switch IP address through the CMC CLI.
1. Establish a Telnet session to the CMC CLI.
2. At the command prompt, type connect switch-x where x is the bay where the switch module is installed. For
example, switch-x can be:
•
Switch-3 for switch module installed in bay B1.
•
Switch-4 for switch module installed in bay B2.
•
Switch-5 for switch module installed in bay C1.
•
Switch-6 for switch module installed in bay C2.
3. At the login prompt, enter the default user name as "admin" and password as "password".
4. Use the appropriate CLI commands to change the IP address of the selected switch module. Refer to your Blade
Server Enclosure CLI documentation.
Using the CMC GUI to set the IP address
To change the IP address, use the following steps:
1. Click the I/O Module Overview in the navigation panel of the CMC menu.
2. Open the CMC application's Setup tab.
3. Enter the new information in the IP Address, Subnet Mask, and Gateway fields as appropriate and click Apply.
4. To enable DHCP, select DHCP Enabled and click Apply.
Dell M8428-k Getting Started Guide
MHWKY
All manuals and user guides at all-guides.com
5 of 160