Chal-tec fun pro 5 Manual Del Usuario página 12

EN
12
• You can pull the handlebar out as far as it will go. Here the handlebar locks
and a pin engages in the safety hole.
• You can also lock the handlebar at any other desired point. To do this, you
need to tighten the Allen screw on the back of the quick release and close
the quick release.
• As an adult, use your weight to test that the handlebars are securely
locked in place. If you can still move the handlebar, tighten screw further.
3. Alignment
Your scooter has a so-called headset. The handlebar itself is secured with a
collar. You must align and secure the handlebar at the beginning!
Close the quick release. Check the
tight fit by wiggling the handlebars.
If the handlebars are not sufficiently
tight, you can tighten the counter
screw to the quick release by hand
or with an Allen key.
Initial situation
The wheel and the handlebars
should form a 90° angle. Or the
wheel should be the direct extension
of the footboard. The more
inaccurate this is set, the more likely
accidents can occur.
To change the alignment, open
the screws of the clamp with the
enclosed on-board tool. It is usually
sufficient to loosen both screws 1.5
turns. The screws should not fall out.