AmazonBasics B089R7J1CQ Manual Del Usuario página 12

Installation - Existing Construction
Step 6: Connect house and fan wires
FIG 1
FIG 2
D
WHITE
WHITE
FIG 3
12
D
BLACK
BLACK
GREEN/
COPPER
GREEN/
COPPER
• Remove screw from junction box cover and
remove cover from junction box on
the fan housing. Note how flange on bottom
of cover is positioned (FIG 1).
• Pull wires through hole of junction box cover.
Using quick connect wire connectors, connect
all electrical wiring from service switch to
D
wiring from fan housing. If needed, refer to
page 6 on using quick connect wire connectors.
NOTICE
3/8 in. trade size with 1/2 in. knockout wire
clamp to secure wiring to junction box cover.
CAUTION
switch do not match wiring from fan housing,
you must determine what each wire represents
before making wire connections. Consult an
electrical contractor if uncertain.
NOTICE
"hot". White wires are typically "common".
Green or bare copper wires are typically
"ground". Do proper electrical testing if
uncertain and/or consult an electrical
contractor.
• When all wires are connected properly,
carefully place all wiring with quick connect
wire connectors into junction box.
Install junction box cover back onto junction
box and install screw. Ensure bottom of
cover flange is inserted correctly. (FIG 3)
It is recommended to use a
If electrical wires from service
Black/red wires are typically