Assembly Protective Feet For Delicate Floors - Extremis PICNIK Instrucciones De Montaje

ASSEMBLY PROTECTIVE FEET
WHAT YOU NEED
2 people
hex key no. 5
+/- 30 min.
1. Remove the protection caps of the
fastening screws of the 4 feet indicated
on the above drawing and loosen these
screws with a 5 mm Allen wrench.
4. Put some Loctite 270 on the adjusting
screws and tighten the 6 pieces for
floormounting with an Allen wrench
number 5 and place the caps on it again.
6 assembly protective feet + maintenance
To fix the protective feet to the Picnik,
all 6 mounted stainless steel feet must be
removed and replaced by 6 stainless steel
feet for delicate floors PP06 with felt on
the bottom.
2. Remove the feet. 3. Replace them by the 6 new feet. The
side with the holes should always be
facing inwards.