Descargar Imprimir esta página

Assembly Floor Fastening; What You Need - Extremis PICNIK Instrucciones De Montaje

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33

ASSEMBLY FLOOR FASTENING

WHAT YOU NEED

2 people
hex key no. 5
+/- 30 min.
1. Remove the protection caps of the
fastening screws of the 4 feet indicated
on the above drawing and loosen these
screws with a 5 mm Allen wrench.
4. Put some Loctite 270 on the adjusting
screws and tighten the 4 pieces for
floormounting  with an Allen wrench
number 5 and place the caps on it again.
5. Now mark the spots on the ground where you want to anchor the table. Put the Picnik
table aside and drill holes at the indicated spots. Use the fixing media most suited
to the type of ground on which you intend to install the Picnik table.
4
assembly floor fastening + assembly floor fastening heavy duty
To anchor the Picnik table to the ground,
4 of the 6 already mounted stainless steel
feet must be removed and replaced by the
4 stainless steel feet of the PFL04 ground
anchor kit.
2. Remove the feet.
3. Replace them by the 4 new feet. The
side with the holes should always be
facing inwards.

Publicidad

Capítulos

loading