Electrical Safety; Carton Contents; Overview (Fig. A) - Black and Decker GTC2451 Manual Del Usuario

If the supply cord is damaged, it must be
x
replaced by the manufacturer or an authorised
Black & Decker Service Centre in order to
avoid a hazard.

ELECTRICAL SAFETY

Your charger has been designed for a specific
mains voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Your charger is double insulated in
accordance with EN 60335; therefore no
earth wire is required.
Mains plug replacement (U.K. & Ireland only)
Should your mains plug need replacing and you
x
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorised
repair agent or a qualified electrician.
Disconnect the plug from the supply.
x
Cut off the plug and dispose of it safely; a plug
x
with bared copper conductors is dangerous if
engaged in a live socket outlet.
Only fit 13 Amperes BS1363A approved plugs
x
fitted with a 3 A fuse (1).
The cable wire colours, or a letter, will be marked
x
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see above). Brown is for Live (L) (2),
blue is for Neutral (N) (4).
Before replacing the top cover of the mains
x
plug ensure that the cable restraint (3) is
holding the outer sheath of the cable firmly
and that the leads are correctly fixed at the
terminal screws.
After replacing the fuse in the moulded plug,
x
make sure that the fuse cover is refitted.
Do not use the plug if the fuse cover is missing
or damaged.
All manuals and user guides at all-guides.com
Never use a light socket.

CARTON CONTENTS

The carton contains:
1 Cordless hedgetrimmer
1 Battery
1 Charger
1 Blade sheath
1 Instruction manual
Carefully unpack all parts.
x

OVERVIEW (fig. A)

1. Front handle switch
2. Trigger switch
3. Lock-off button
4. Ventilation slots
5. Guard
6. Battery
7. Charger
8. Charging indicator
9. End of charge indicator
10. Blade sheath
ASSEMBLY
Before assembly, remove the battery from
the tool.
Fitting and removing the battery (fig. B)
To fit the battery (6), line it up with the
x
receptacle on the tool. Slide the battery into
the receptacle and push until the battery snaps
into place.
To remove the battery, push the release
x
button (11) while at the same time pulling the
battery out of the receptacle.
USE
Let the tool work at its own pace.
Do not overload.
Charging the battery (fig. A)
The battery needs to be charged before first use
and whenever it fails to produce sufficient power on
jobs that were easily done before.
E N G L I S H
9