Yamaha YDRE 2008 Manual De Operación página 44

JW2
MAINTENANCE
Transaxle Oil
To check transaxle oil level:
1. Place the golf car on a flat, level
surface.
2. Remove seven plastic rivets 1
and two bolts 2, and remove the
bag holder insert 3.
3. Place an oil pan under the
transaxle case.
4. Clean area around servicing plug 4.
5. Using an 8 mm hex wrench,
remove transaxle oil servicing
plug located on the rear of the
transaxle case.
Y-1215
6. Transaxle oil should be at the top
of the oil servicing hole or just
beginning to run out of hole.
NOTICE
Do not allow foreign material to
enter transaxle.
7. If needed, add SAE80 W90 API
GL-5 limited slip high perfor-
Y-1214
mance gear oil until it is at the
top of the plug hole or just begin-
ning to run out of servicing hole.
TIP
The YDRE Golf Car is equipped with
an internal wet brake. Use of oil other
than SAE80 W90 API GL-5 limited
slip high performance gear oil will
cause brake noise.
8. Install the transaxle servicing
plug and tighten to 120-168 in•lb
(1.4-1.9 m•kg, 14-19 Nm).
9. Install the bag holder insert
3 and secure with two bolts 2
and seven plastic rivets 1.
1
2
3
4
5
6
7
8
9
10
11
7-17