Taurus ALPATEC DH10M Manual Del Usuario página 9

- Do not move the appliance while in use.
- Use the appliance handle, to catch it or move it.
- Do not use the appliance if it is tipped up and do not
turn it over.
- If you use the appliance in a bathroom or similar place,
unplug the appliance from the mains when it is not in
use, even if it is only for a short while, as proximity to wa-
ter involves a risk, even if the appliance is disconnected.
- Unplug the appliance from the mains when not in use
and before undertaking any cleaning task.
- This appliance is for household use only, not professio-
nal, industrial use.
- This appliance should be stored out of reach of children
and/or the disabled.
- Do not store the appliance on areas where the tempe-
rature could be lower than 5ºC
- Do not expose the appliance to extreme temperatures.
- Any misuse or failure to follow the instructions for use
renders the guarantee and the manufacturer's liability
null and void.
Installation
- Be sure to remove all packaging material from inside
the appliance.
- Do not remove the support feet or wheels from the
appliance.
- Leave at least 20 cm space
around the unit.
- The ambient temperature range for the appliance is
5º-35ºC.
Instructions for use
Use:
- Unroll the cable completely before plugging it in.
- Connect the appliance to the mains.
-When the power is on, whenever it is running or not, the
on/off power indicator will light on.
-Press this button to turn on/off the unit.
-Do not unplug the power cord directly to force the ma-
chine stop working directly.
Water full indication
- When water tank is full, indicator lights shows,
- You must empty the water tank and put it back to
correct position.
Water drainage:
- The Water full indication will show red when water tank
is full, warning will be given when capacity 1.5L has been
reached.
- Take out the water tank, empty the water inside.
- Put the water tank back into the dehumidifier
CAUTION:
- Do not remove the float from the water tank; otherwise,
the machine will not stop to work when the water tank is
full. Then the water will be overflow that maybe makes
damage to your floor (fig.1)
Manual DH10M Alpatec.indb 9
All manuals and user guides at all-guides.com
- Drain the water collection tank completely when water
tank is full and reset your setting
- If the water tank is dirty, clean by cool water or warm
water, cannot use cleaner, steel wool, chemical rag
duster, gas oil, benzene, thinner or other solvent to clean
it, otherwise, it would damage the water tank and lead
to leakage.
- When put the water tank back to the unit, please use
two hands to push the water tank into the machine to the
correct position. Or the water full indication will still show
red and the machine can not work. (Fig. 2)
Continuous drainage:
- Open the cover on the back of the dehumidifier. (Fig.3)
- Take out the water tank.
- Remove the plastic at the water level place.(Fig. 4)
- Insert a PVC pipe with 9.5mm inner diameter 9.5mm,
and the recommended length is 300mm; put the other
side into a container, such as a bucket. (Fig. 5)
NOTE: PVC pipe is not included. Need to be buy
separately.
-Put the drain pipe to the specific location.(Fig. 6)
CAUTION:
- Never block the water outlet or the pipe, water will flow
into the water tank if it is blocked.
- Never bend the drainage pipe and be always lower
than the outlet.
- Must close the cover when no need continuous drai-
nage.
Auto defrost, low temperature working
-After 30 minutes of continuous operating for
compressor,and if the temperature sensor detects that
the copper tube is lower than 0ºC for one minute the
compressor would stop operating for defrosting for ten
minutes while the fan keeps operating.
-After defrosting for ten minutes, or when the tempera-
ture sensor detects that the copper tube is higher than
10ºCfor 30 seconds, the defrosting will be finished and
the compressor will restart operating after three minutes
for delay protection.
Note: The On/Off light twinkles when the machine is
defrosting.)
Once you have finished using the appliance:
- Stop the appliance by releasing the pressure on the on/
off button.
- Unplug the appliance from the mains.
- Put on the protective cover.
- Remove the water from the water tank.
- Clean the appliance.
Carry handle/s:
- This appliance has a handle on the upper part of the
body, which facilitates comfortable transportation
3/11/15 13:24