STEINEL L 710 S Manual Del Usuario página 16

How does the user-friendly economy
programme work?
The sensor-switched light does not have an integrat-
ed clock. The middle of the night is only determined
on the basis of the length of darkness phases.
To work perfectly, therefore, it is important for the
sensor-switched light to be permanently connected
to the power supply during this period. During the
first night (calibration phase), basic light level remains
activated throughout the night. The values are saved
even in the event of a mains power failure. We do not
recommend interrupting the power supply in this the
programme. The values are determined over several
nights. The sensor-switched light should, in the event
of any fault occurring, be monitored over several
nights to ascertain whether the switch-off time moves
towards midnight.
User-friendly programme
– Soft light start + basic light level
– Basic light level ON from twilight setting selected
What is basic light level?
Basic light level provides continuous night-time
illumination at approx. 10% light output. The light
only switches to maximum output (100%) for the
time selected in response to movement in the de-
tection zone. The light then returns to the basic light
level (approx. 10%).
Nightmatic programme
– Soft light start, no basic light level, no movement
evaluation
– Switches ON at 100% if the light level falls below
the level set
Night economy mode (Fig. 6.2. J)
The light can be switched OFF automatically at
night to save even more electricity. The electronic
system does not have a clock. All times are com-
puted by the microprocessor on the basis of light
levels at twilight. Seasonal changes in light levels
are identified automatically and taken into account.
– Control dial set to OFF = light ON all night
– Control dial set to ECO = light OFF for 3.5 hours
in the night
– Control dial set to ECO+ = light OFF for 7 hours
in the night
ON/OFF in the morning (Fig. 6.2. K)
The night economy mode always ends in the early
hours of the morning between approx. 4 and
5 a.m. After then, the luminaire switches ON again
automatically when it gets dark.
– Control dial set to ON = light switches ON auto-
matically at dawn.
– Control dial set to OFF = light stays OFF in the
morning.
Manual override L 710 S (Fig. 6.3)
1) Activate manual override:
Switch OFF and ON twice. The light is set
to manual override for 4 hours. Then it returns
automatically to sensor mode.
2) Deactivate manual override:
Switch OFF and ON once. Light goes out or
switches to sensor operation.
Important:
Switching must take place within 0.2 to 1 second.
Adjusting the detection zone L 710 S
(Fig. 6.4/6.5/6.6/6.7)
The detection zone can be limited to suit require-
ments. The shrouds supplied with the unit can be
used to mask out as many lens segments as you
wish. This prevents the light from being activated
unintentionally, e.g. by cars, passersby etc., and
allows you to target danger spots. The shrouds can
be cut along the grooved vertical divisions. Then
you simply clip them onto the lens.
7. Maintenance
The product requires no maintenance.
The light can be cleaned with a damp cloth (without
detergents) if dirty.
Important note: the control gear cannot be replaced.
8. Disposal
Electrical and electronic equipment, accessories
and packaging must be recycled in an environmen-
tally compatible manner.
Do not dispose of electrical and electronic
equipment as domestic waste.
EU countries only:
Under the current European Directive on Waste
Electrical and Electronic Equipment and its imple-
mentation in national law, electrical and electronic
equipment no longer suitable for use must be col-
lected separately and recycled in an environmentally
compatible manner.
– 16 –