About This Document; General Safety Precautions - STEINEL L 710 S Manual Del Usuario

GB

1. About this document

Please read carefully and keep in a safe place.
– Under copyright. Reproduction either in whole or
in part only with our consent.
– Subject to change in the interest of technical
progress.
Symbols
!
Hazard warning!
Reference to other information in the
...
document.

2. General safety precautions

Disconnect the power supply before
!
attempting any work on the unit.
• During installation, the electric power cable being
connected must not be live. Therefore, switch off
the power first and use a voltage tester to make
sure the wiring is off-circuit.
• Installing these units involves work on the mains
voltage supply; installation must therefore be
carried out professionally in accordance with the
applicable national wiring regulations and electri-
cal operating conditions (e.g.: DE-VDE 0100,
AT-ÖVE/ÖNORM E 8001-1, CH-SEV 1000)
• Only use genuine replacement parts.
• Repairs may only be made by specialist work-
shops.
3. L 710 S / L 710 N
Proper use L 710 S
– LED light with sensor for indoor and outdoor wall
mounting.
The integrated infrared sensor detects the invisible
heat radiated from moving objects (people, animals,
etc.). The heat detected in this way is converted
electronically into a signal that switches the light
ON automatically. Heat is not detected through
obstacles, such as walls or panes of glass, and will
therefore not activate the light.
Important:
The most reliable way of detecting motion is to
install the sensor-switched light with the sensor
aimed across the direction in which a person would
walk and by ensuring that no obstacles (such as
trees and walls, for example) obstruct the line of
sensor vision. Reach is limited when walking directly
towards the light.
Proper use for L 710 N
– LED light with Nightmatic function for indoor and
outdoor wall mounting.
The integrated Nightmatic function measures ambi-
ent brightness and automatically switches the light
ON at the selected level of darkness and OFF again
in line with various setting options.
L 710 S package contents (Fig. 3.1)
– Luminaire
– Wall mount
– Two screws
– Two wall plugs
– Three spacers
– Shrouds
L 710 N package contents (Fig. 3.2)
– Light
– Wall mount
– Two screws
– Two wall plugs
L 710 S product dimensions (Fig. 3.3)
L 710 N product dimensions (Fig. 3.4)
L 710 S product components (Fig. 3.5)
A Sealing plug
B Wall mount
C Connecting terminal
Luminaire enclosure
D
Retaining strap
E
F Basic light level
G Twilight setting
H Time setting
I Sensor unit
L 710 N product components (Fig. 3.6)
Sealing plug
A
Wall mount
B
C Connecting terminal
D Light enclosure
E Retaining strap
J Night economy mode
G Twilight setting
K ON/OFF in the morning
L 710 S detection zone (Fig. 3.7/ 3.8/3.9)
Luminous intensity distribution (Fig. 3.10)
– 14 –