Add Engine Oil And Fuel - Troy-Bild 01904 Manual Del Propietário

Section 3: Assembly
2. Secure tray to handle with self tapping screws using a
#2 phillips screwdriver. Ensure screws are tight but not
crushing the plastic accessory tray.
3. Place handle assembly onto handle supports connected
to main unit. Make sure holes in handle align with holes
on handle supports (Figure 2).
7. Pinch chemical hose and slide it into metal clip as
shown in Figure 5.
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
4. Insert"L" bolt through hole on left side of handle
(viewing from handle side of unit) and attach plastic
knob.Tighten knob by hand (Figure 3).
S.
Insert carriage bolt through right side hole from
outside of unit and attach a plastic knob from inside of
unit (viewing unit from the handle side).Tighten by
hand (Figure 3).
6. Insert"J" hook into second from left slot in accessory
tray (Figure 4).
8.
Tilt unit up by handle and attach metal clip to rib on
center undersideof accessory tray (Figure 6). Slide
chemical hose through metal clip so that it is tight but
not kinked.
Add Engine Oil and Fuel
• Placepressure washer on a level surface.
• Refer to engine owner's manual and follow oil and fuel
recommendations and instructions.
CAUTION
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instructionwill void warranty.
NOTE: Check oil often during engine break-in. Refer to
engine owner's manual for recommendations.