Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
HOW
TO USEYOUR
PRESSURE WASH ER
If you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-888-611-6708.
To Start
Pressure Washer
To start your pressure washer for the first time, follow
these instructions step-by-step.This starting information
also applies if you have let the pressure washer sit idle for
at least a day.
I.
Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
3.6 gallons per minute and no less than 20 PSIat
pressure washer end of garden hose.
2.
Check that high pressure hose is connected to spray
gun and to pump. See "Preparing PressureWasher for
Use" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure
washer pump.Turn ON water.
CAUTION
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Squeeze trigger on gun until you have a steady stream
of water.This
purges pump of air and impurities.
6.
Attach nozzle extension to spray gun (Figure 10).
Tighten by hand.
7.
Choose spray tip you want to use and insert it into
nozzle extension. See"How to Use SprayTips" on
page I 0.
8.
Engagesafety latch to spray gun trigger (Figure I I).
Safety Latch
9.
Move variable pressure control lever to "High"
position, shown on engine as a rabbit (Figure 12).
\
Publicidad
Tabla de contenido
