Safety Information - Tripp-Lite B130-101 Manual Del Propietário

Installation
Local Unit
Note: You should test to make sure the entire installation works properly before pulling
cables through ceilings/walls.
1 Connect the computer to the Local Unit "Source Video" port using a
HD15 monitor cable.
2 You can choose to connect a local monitor to the "Local Video" port on
the Local Unit.
3 Connect the Local Unit to the Remote Unit using a patch cable. The
B130-101 can extend a video signal up to 500 ft. (150 m) using a
standard Cat5/5e/6 cable.
4 Connect the Remote monitor to the "Video" port on the Remote Unit
using a HD15 monitor cable.
5 Plug the included 12.6V, 3A power supply into the Local Unit.
6 Turn the display(s) on first.
7 Turn on the computer.
8 If the video on your monitor is either too dark or too light, use the "Gain"
adjustment under the Remote Unit to modify it.
9
If the video on your monitor shows a fuzzy or "ghosting" effect, use the
"EQ" adjustment under the Remote Unit to modify it.

Safety Information

A. To reduce the risk of electric shock, do not expose this product to
moisture.
B. Operate this product using only the included external power supply. Use
of other power supplies could impair performance, damage the product,
or cause fire.
164 93-2849.indd 4
All manuals and user guides at all-guides.com
Remote Unit
4
12/1/2008 4:50:41 PM