BaByliss E842XE Manual Del Usuario página 6

ENGLISH
E842XE BEARD
MOUSTACHE TRIMMER
1. 1 cutting guide for 30
lengths (from 0.5mm to
15mm, in 0.5mm increments)
2. 2 cutting blades
different widths: 32mm to
trim your beard and 7mm to
style it
Moveable blade:
- Exclusive three-dimensional
etching process:
exceptionally sharp cutting
edge.
- CMS (Chrome-Molybdenum-
Stainless Steel):
hardwearing and
stainless steel blade.
Fixed Blade:
- TITANIUM coating:
increased longevity
These 2 technologies provide
a perfect surface condition
and combining them is ideal
for reducing the
coefficient.
3. 1 special '3-day beard'
cutting guide
4. ON/OFF button (2 speeds)
5. Wheel to adjust the cutting
length
6. power indicator light
7. plug for use on the mains
and for charging
8. Cleaning brush
IMpORTANT
REGARDING
BATTERIES OF THIS UNIT
To obtain and maintain the
AND
longest battery autonomy
possible, allow it to charge
for 16 hours before using it
for the first time and then
approximately every three
with
months. Full autonomy of
the unit will only be obtained
after three complete recharge
cycles.
CHARGING THE TRIMMER
for an
1. Plug the cord into the unit
and connect the transformer.
Before using the trimmer
for the first time, allow it to
ultra-
charge for 16 hours. Make
100% sure the trimmer's switch is in
the OFF position.
2. Check that the charging
indicator light is lit.
for
3. A full charge provides a
minimum of 30 minutes' use
of the trimmer.
4. Subsequent charges should
also be 16 hours.
friction
USE ON THE MAINS
To use the trimmer on the
mains, plug the chord directly
into the unit.
Plug the trimmer, in the OFF
position, into the mains and
switch ON (If the battery is very
weak, wait about 1 minute).
IMPORTANT! Use only the
adapter that is supplied with
the trimmer Ref. E842XE Voltage
= 3V – Current 1000mA.
HANDLING THE COMB GUIDE
The comb guide is very practical
6
INFORMATION
THE NI-MH